Warehouse electrical management 2021-06-20 21:14:02 (1) The electrical installations of the warehouse must comply with the current national standards for electrical design, construction and installation acceptance. (2) Movable lighting fixtures are not allowed to be installed in the warehouse, and must be reported to the fire department for approval when they are used, and safety protection measures must be taken. (3) The electrical installations of warehouses storing the same types of flammable and explosive goods must comply with the current national electrical safety regulations for explosive hazardous locations; high-temperature lighting fixtures such as iodine tungsten lamps and incandescent lamps over 60 watts are not allowed. When using low-temperature lighting fixtures such as fluorescent lamps and other flame-proof lighting fixtures, fire protection measures such as heat insulation and heat dissipation should be adopted for the ballast to ensure safety. (4) Each warehouse in the warehouse area should install a switch box separately outside the warehouse. When the storage personnel leave the warehouse, they must switch off the power; it is forbidden to use substandard safety devices. (5) It is strictly forbidden to stack goods around the electrical appliances of the warehouse and under the overhead lines. Protective covers must be installed on the parts of mechanical equipment such as lifting and palletizing that are prone to sparks; the warehouse must be in accordance with the national regulations on lightning protection design and installation Set up lightning protection devices and perform regular inspections to ensure their effectiveness; electrical equipment in the warehouse must be installed, inspected, and maintained by qualified electricians, and electricians should strictly abide by various electrical operating procedures.